Attach regulator to your fresh air tank, one end of the kit hose to the quick coupler on the regulator and the other end to your Air Hammer. Regulator is pre-set for correct pressure 100 to 150 PSI. Attach a chisel on your Air Hammer by screwing the safety spring on to the front of the hammer.

CAUTION: Use only on fresh air tanks-never use oxygen or acetylene tanks.

11" long flat chisel for general cutting
6" short, flat chisel for tight spots
7" panel cutter for fast panel cutting

Your standard small fresh air tank will operate the air hammer for approximately 6 minutes of continuous operation.